This cold weld compound is great for many quick and permanent fixes. It can be used on a wide variety of surfaces and materials. One tube is called Steel and the other is Hardener. Just squeeze out equal parts of hardener and onto a spare piece of card board or other scrap material and mix thoroughly for about 30 seconds. Working time is around one minute and the compound will fully cure about four minutes, but this depends on temperature and humidity.
1oz. Hardener and 1oz. Steel Compound Tubes
Quick Set Fully Cures In 4 Minutes
Resists Temperatures Up to 300°F (150°C)
High Temperature Pressure Resistant
An Alternative to Welding
Works on Aluminum Brass Bronze Castings Copper & Steel Surfaces
Can be Drilled Tapped Machined Filed or Sanded
Resistant to Gasoline Diesel Fuel Oil Water and Antifreeze
Works Great On:
- Casting Defects
- Cracked Manifolds
- Keyways
- Radiator Seams
- Rear End Casings
- Reparing Cracked Transmission
This Pro Weld Cold Weld Compound is Made In The USA
I figured on dropping you my testimonial a while back but just made time today. Well if anyone really reads these things other than me, you can trust 12Volt-Travel. They have never let me down and I've been a customer since 2011. First purchase was out of pure necessity that I gave them a chance. Small order delivered on time and no junk mail. My company has grown substantially over the years and as a result so have my orders and my trust in 12Volt-Travel. This company Rocks! Go With It!!
Hopefully I'm able to give the next person a little reassurance. Z. Tolberth — , PA — ZZ Haulers
