Boost Your TV Signal
with Winegard®. This super compact TV amplifier runs on 5V DC USB power and is built to bring in the new digital signal. A 110V to 5V USB power adapter is included but you can use any 5V USB power port, even the one on the side of your TV! The only real requirement is that your antenna is not already amplified.
Making the Connections
couldn't be easier. The booster has a single "coax in" marked as "Ant" and a single "coax out" marked as "TV". Connect the TV end to your TV and the Ant. end to your (non-amplified) TV antenna. Next step is to plug the USB power cable into the booster. That's it!
The 5V DC powered LNA-100 is meant for use with in-door antennas to keep the unit from exposure to weather as well as keeping cable runs short. If you have an out-door antenna mounted on your truck, RV or off-grid home and the cable length between your TV and antenna are less than 50ft this booster will work for you, just keep it inside near your TV.
- Model LNA-100 amplifier
- For use with indoor non-amplified antennas
- Gain: 20 dB (typical)
- Noise Figure: 1.0 dB (typical)
- Bias (power supply): +5 V at 130 mA
- Designed and Assembled in USA
I had completely lost all hope in our suppliers. My driver (James) found your ad in some magazine and brought to my attention that you carry 12-Volt TV's. To my surprise your sales rep said that you would be able to fulfill my requirements. Just four days later; I was elated to find the entire shipment had arrived complete, in good condition and one day early. All but a few units have been installed in our trucks and we've had no problems with any of them.
Sonia T. Sonia T. — , IN —